Page 1 of 1
Need holes drilled in Sanke keg
Posted: Wed Apr 11, 2012 12:53 pm
by geauxwillett
Does anyone know who can drill some holes in converted sanke kegs? I had a helluva doing just the one for my valve. Took an hour or so. Before I go buy eqpt to do this, I wanted to see if anyone could do this.
Re: Need holes drilled in Sanke keg
Posted: Wed Apr 11, 2012 12:56 pm
by geauxwillett
I was told Wayne Yandell may be able to help me, but not sure how to get a hold of him.
Re: Need holes drilled in Sanke keg
Posted: Wed Apr 11, 2012 2:16 pm
by groovyslick
all you need is the proper step bit. I can show you how.
email me a
[email protected]
Re: Need holes drilled in Sanke keg
Posted: Wed Apr 11, 2012 8:21 pm
by geauxwillett
Thanks. Sent you an email.
Re: Need holes drilled in Sanke keg
Posted: Fri Apr 13, 2012 8:33 am
by RobDrechsler
carbide drill bit & cutting oil
slow speed while drilling... lots of oil, constantly..
Re: Need holes drilled in Sanke keg
Posted: Sun Sep 02, 2012 9:47 am
by AmbassadorBrewing
I used the cheap step bits from harbor freight, drilled three holes in two kegs with an 18v cordless ryobi drill. Drilled a starter hole with a normal metal bit then used the thinnest step bit to widen it and then moved to the wider step bit. Always stop and measure the hole, you can only make it bigger.